Page 1 of 1

OmniAdapter issue

Posted: Thu Mar 07, 2013 9:54 am
by Jason Taylor
I have an Omnipliance with a 4 channel 1Gig OmniAdapter. 2 ports are fiber and 2 ports are copper. I'm having a problem running multiple captures using different channels on the card. I have created a new capture using channel 1 (copper). If I create an addition capture and set it to use channel 2 (also copper), the other capture also changes to channel 2. I've upgraded my engine to 7.1, but the issue is still there. Is this a limitation I'm going to have to live with or is it just a bug?

RE: OmniAdapter issue

Posted: Thu Mar 07, 2013 1:49 pm

You will need to use software channel filters to accomplish this, as the OmniAdapter will always appear as a single interface to OmniPeek, regardless of the the number of ports on the card.

You could then create four different captures, each with a channel filter and isolate the traffic that way.

We recommend you contact Support directly so they can assist you with this:

RE: RE: OmniAdapter issue

Posted: Thu Mar 07, 2013 1:55 pm
by Jason Taylor
Thanks for your reply.