Page 1 of 1

Issue for Aruba Remote Adaptor

Posted: Sun Mar 22, 2015 11:40 pm
by pclin31
Hi WildPackets,

Recently, we buy a license of Omnipeek 8.0 and Aruba IAP-225 to capture the 3 stream traffic.
The following link demonstrate that how to setup the remote packet capture on Omnipeek 7.9
http://pnmackenzie.tumblr.com/post/76777894866/3-stream-802-11ac-packet-capture-with-the-aruba
However, we still get incorrect sniffer information (i.e., Signal, Data Rate) from Omnipeek 8.0 + Aruba IAP-225 (firmware version 6.4.2.0-4.1.1.1)
Is this issue related to Omnipeek version?

Re: Issue for Aruba Remote Adaptor

Posted: Mon Mar 23, 2015 8:05 am
by DJWP
Hello-

Please contact Tech Support so we can gather details on your issue and isolate it as quickly as possible. We also recommend upgrading to the current version of OmniPeek which is 8.1.1:

http://www.wildpackets.com/support/contact