Page 1 of 1

Trigger on Filter

Posted: Thu Jul 20, 2017 7:37 pm
by dsievert@tcfbank.com
Hello Support,

I'm running OmniPeek V9.2 and attempting to set up a start trigger based upon a filter, but when I attempt to select that option, it is grayed out and I cannot navigate/select a filter. It *seems* that the instructions indicate that this is a valid method, however, the GUI might not be aware?

Thanks

Re: Trigger on Filter

Posted: Mon Jul 24, 2017 3:29 pm
by DJWP
We cannot reproduce this here, it seems to work fine. Please upgrade to the current version, which is 10.1. In capture options, select Trigger, click start trigger, then Trigger event, then click Filter and select the filter you would like to trigger on. Keep in mind, this does not filter traffic at all, it just starts the capture.

If you still have issues with this, contact Support directly:

https://www.savvius.com/support/contact