OmniPeek Support

Capture into the past and Trigger Stop

Posts: 1
Joined: Fri Sep 19, 2008 10:54 am

Capture into the past and Trigger Stop

Postby stephanstricker » Fri Sep 19, 2008 10:59 am

I am using OmniPeek 4 and I have two questions.

1. Is it possible to start on a trigger but capture the data starting 2 seconds before this trigger. The reason is I am looking for an error but of course it is important to see what happened before the trigger was fired.

2. I using continuous capturing and I want to stop on a trigger. Additionally I want to limit the files. This works fine when I use a start trigger condition but not if I use only the stop trigger condition. In that case OmniPeek keeps on creating new files. Is there something to remember when I use the stop trigger?



Return to “OmniPeek Support”

Who is online

Users browsing this forum: No registered users and 1 guest