OmniPeek Support

Web Views - Only shows some of the contents

Posts: 3
Joined: Sat Jul 04, 2009 3:15 pm

Web Views - Only shows some of the contents

Postby megamall » Sun Jul 05, 2009 12:57 am

I'm trying to analyse the web traffic on my network..
Under the Contents tabs, I notice that only some of the contents are displayed. Why doesn't it display all the contents captured over the network?

In the WildPackets FAQ, it says
Return to top of page Why can???t I see the new Web Views in remote captures or forensic searches?

Currently, web view reassembly is only supported on the console.

What is exactly meant by this? What do you mean by console?

I'm using Omnipeek 6.0.2 by the way..
Camry Ts-01
Last edited by megamall on Sat Feb 12, 2011 6:01 pm, edited 1 time in total.

Posts: 692
Joined: Tue Oct 30, 2007 11:42 am

RE: Web Views - Only shows some of the contents

Postby DJWP » Fri Jul 10, 2009 3:12 pm

Forensic searches can only be done when OmniPeek (the console) is communicating the OmniEngine (the probe). OmniEngine is our distributed software. If you bring a file across from the engine machine to the console machine and open it with OmniPeek Enterprise directly, the Web Views will be visible-

Return to “OmniPeek Support”

Who is online

Users browsing this forum: No registered users and 1 guest