Page 1 of 1

Cisco Remote Adapter

Posted: Wed May 30, 2012 11:43 am
by skiverg
Used to work in prior editions?

Cisco 1142 AP, 5508 Controller.

In OmniPeek Pro -> Tools -> Options -> Analysis Modules ->
Cisco Remote Adapter enabled

config network ip-mac-binding disable
config ap mode sniffer APNAME
config ap sniff 802.11a enable 36 192.168.26.26 APNAME

show ap config 802.11a

Everything seems to be in order.

No packets captured.

RE: Cisco Remote Adapter

Posted: Wed May 30, 2012 1:30 pm
by DJWP
Do you have the Analysis Modules enabled in the Analysis Options dialog in the General Capture options?

RE: RE: Cisco Remote Adapter

Posted: Wed May 30, 2012 1:36 pm
by skiverg
Yes the analysis module is enabled

RE: RE: RE: Cisco Remote Adapter

Posted: Wed May 30, 2012 2:36 pm
by DJWP
If you have your controller configured correctly, and have current maintenance, contact Tech Support:

http://www.wildpackets.com/resources/to ... lugin_tips

http://www.wildpackets.com/support/contact

Re: Cisco Remote Adapter

Posted: Wed Nov 20, 2013 1:35 pm
by skiverg
I have an updated file on How to capture using Cisco Wireless Adapter in Omnipeek. Using NCS Prime 1.3.

Message me if you want the .rtf file.

Re: Cisco Remote Adapter

Posted: Fri Nov 22, 2013 9:27 am
by DJWP
Sure, send your tip to us using the support contact form on our website.

Much appreciated-