Page 1 of 1

Is there a way to see p2p (WiFi Direct) protocol?

Posted: Sun May 01, 2011 2:03 am
by selgavi
Hey,

Is it supported?

Thanks!

RE: Is there a way to see p2p (WiFi Direct) protocol?

Posted: Mon May 02, 2011 9:06 am
by DJWP
The next release of OmniPeek will contain decoders for most messages in the new P2P Wi-Fi Direct protocol.

RE: RE: Is there a way to see p2p (WiFi Direct) protocol?

Posted: Mon May 02, 2011 9:17 am
by selgavi
Can you estimate when it should be? would it be possible to get even Alpha release of those decoders?

RE: RE: RE: Is there a way to see p2p (WiFi Direct) protocol

Posted: Mon May 02, 2011 9:23 am
by DJWP
There are no pre-releases of OmniPeek code. The next version should be released by the end of Q2.

RE: RE: RE: RE: Is there a way to see p2p (WiFi Direct) prot

Posted: Mon May 02, 2011 9:34 am
by selgavi
I have just bought 5 licenses of latest Omnipeek version which were not activated yet.
I did not bought the maintanance fee, will I be able to use those p2p decoders?
Can you advice me how to proceed with it?

Thanks in advance for your quick response,
Shmulik

RE: Is there a way to see p2p (WiFi Direct) prot

Posted: Mon May 02, 2011 9:55 am
by DJWP
If you have not purchased maintenance, Technical Support and software updates will not be available to you.

Please contact sales@wildpackets.com if you would like to look into purchasing maintenance on your software.

RE: RE: Is there a way to see p2p (WiFi Direct) prot

Posted: Mon May 02, 2011 9:57 am
by selgavi
Thank you, I will,

Shmulik

RE: RE: RE: Is there a way to see p2p (WiFi Direct) prot

Posted: Mon Jul 18, 2011 2:52 pm
by selgavi
Hi there,

Does the p2p decoding was implemented?

Thanks,
Shmulik