Drivers

which driver is needed?

caihkai
Posts: 3
Joined: Thu Jun 26, 2008 1:41 am

which driver is needed?

Postby caihkai » Thu Jun 26, 2008 1:56 am

My wireless card is WAG511 v2. Its chipset is AR5001X+.

Would you please tell me which driver I can install for it?


Thank you very much.

DJWP
Posts: 687
Joined: Tue Oct 30, 2007 11:42 am

Postby DJWP » Thu Jun 26, 2008 8:02 am

The Atheros 3.0.1.12 driver may work. It is installed with OmniPeek and can be found at:

C:\Program Files\Wildpackets\OmniPeek\Driver

These drivers are not supported with any other software.

caihkai
Posts: 3
Joined: Thu Jun 26, 2008 1:41 am

Postby caihkai » Fri Jun 27, 2008 1:16 am

Thank you very much. I installed Atheros 3.0.1.12 for NetGeat WAG511 v2 wireless card. However, it seems not work.

The steps I conducted are:
1. install OEM driver for my wireless card;
2. install omniPek personal 4.0;
3. install the special driver Atheros 3.0.1.12

The test results are as follows:
1. without running omniPeek, the card can connect to AP and communicate;
2. once I run omniPeek, the connected wireless network became disconnected; then I reconnect the wireless network, but I got nothing when doing capture.

In this case, what is the possible reason and is there some way to fix it?

Thank you very much.

DJWP
Posts: 687
Joined: Tue Oct 30, 2007 11:42 am

Postby DJWP » Fri Jun 27, 2008 8:14 am

When you are capturing, the adapter is put into RF monitor mode and is disconnected from the network. This is normal. You would need to have some other source of wireless traffic from another client and/or AP to see traffic.

thenewday007

RE:

Postby thenewday007 » Sun Oct 09, 2011 10:51 pm

Hi,I'm new here.This forum is very interesting that I like it very much.

cheap wow gold | RS Gold | Maple Story Mesos | buy aion kinah


Return to “Drivers”

Who is online

Users browsing this forum: No registered users and 1 guest